Control each entrance separately
Choose the front entrance, side entrance or stockroom shutter through its own channel without sending commands to other independent shutters.
PHONE CONTROL FOR SHOP SHUTTERS
Control your shop shutters from your phone.
Bring compatible shop and commercial shutters together in the KumandaLink app. Control separate entrances individually or group shutters you use together. Add a status sensor to each shutter whose open/closed status you want to see.
Use-case illustration
Phone control1 / 5 / 15
KumandaLink adds phone control to existing security shutters with compatible remote and receiver models. Connect the device to power and pair it using your working remote. Each independent shutter uses one channel, with commands determined by the existing controls. Control away from the premises requires internet access on both your phone and KumandaLink. Open/closed status requires an additional sensor on each monitored shutter.
Group shutters you use together
Group compatible shutters to suit your working routine. Each shutter remains available through its individual channel.
Access your controls while away
Use mobile data to send supported commands when both your phone and KumandaLink at the premises have internet access. Existing handheld remotes stay available.
EXAMPLE CHANNEL PLAN
Example: three independent shop shutters
Separate front, side and stockroom shutters use three channels, leaving two available on the 5 Channel model. Each model must be compatible and within wireless coverage.
This is an illustrative setup. Model compatibility and wireless coverage are checked separately.
Keep your existing shutter remote
Initial pairing uses your working remote. After setup you can operate compatible shutters through either that remote or the app. Different remote and receiver models are checked individually, including when multiple brands are installed.
- Share front and back photos of each different remote.
- Include a receiver label if visible without opening its enclosure.
- Tell us how many shutters operate independently.
Plan capacity and placement together
The 1, 5 and 15 Channel options describe control capacity. Shutters on different sides or floors of a building also require a wireless coverage check before planning a single device.
The open/closed status sensor reports only those two states. It does not report lock, alarm or obstacle detection information, or perform a safety check.
01Can I control an existing automatic shop shutter from my phone?
You can add phone control if its remote and receiver model is compatible. Send photos of your working remote so we can confirm the supported commands before purchase.
02How many channels do open, stop and close use?
Supported opening, stopping and closing commands for one independent shutter use one channel. Do not count remote buttons as separate products.
03Can different shutter brands share one device?
Models confirmed compatible can use separate channels on the same KumandaLink, including products from different brands. Each different remote and receiver requires a compatibility check.
04What if the internet at the shop goes down?
Local control works without internet when your phone and KumandaLink share a working local Wi-Fi network. Your handheld remote also stays available. Control from elsewhere requires internet access at both ends.
05Will I need to pair everything again after a power cut?
No. KumandaLink retains pairings and settings. The device needs a power connection to operate.
06Can the app show whether a shutter is open or closed?
Yes, with one additional open/closed status sensor for each independent shutter you want to monitor. The sensor does not measure intermediate positions or opening percentage, or report whether a lock is engaged.
START WITH THE RIGHT MODEL
Check compatibility